Project Overview
Application context and heating arrangement.
On-site heating system connected to reaction kettle equipment for batch temperature control.
ApplicationChemical and adhesive production
Heating EquipmentThermal oil heating / gas-fired mold temperature controller
Application Requirement
A batch reaction kettle needs controlled heat transfer through a jacket, coil or circulation loop while the product, viscosity and reaction profile affect heat demand.
Recommended Configuration
Thermal-oil heating or gas-fired mold temperature control equipment can be reviewed for kettle volume, jacket design, circulation route and target process temperature.
Project Details
Vessel dataConfirm kettle volume, jacket or coil area, material, pressure condition and insulation.
Process profileConfirm starting temperature, target temperature, heat-up time, holding time and batch frequency.
Medium and pumpConfirm thermal oil grade, circulation flow, pipe diameter, valve layout and expansion tank requirements.
Acceptance documentsPrepare commissioning data for inlet / outlet temperature, circulation condition, alarms and batch acceptance.
Observed Installation
The site photo shows a thermal-oil heating unit connected beside reaction-kettle equipment through a compact circulation layout.
Documentation Scope for This Reference
- The site image supports the visible equipment layout and installation context described on this page.
- The listed project details are a selection checklist; they are not presented as measured values for the photographed installation.
- Temperature stability, capacity, energy use, service life and production improvement require order-specific test or commissioning records.
- A similar process name does not establish suitability until heat duty, scale, utilities, controls and acceptance criteria are compared.
Simplified Heating Flow
Site utilityYigao heating unitHeat-transfer circuitChemical and adhesive productionTemperature control
Information Required for Selection
- Production line dimensions, drawings and installation photos.
- Material, process temperature, heating medium, airflow or circulation data.
- Power, fuel or voltage condition, control-zone count and safety interlock requirements.
- Destination country, required standards, acceptance criteria and inspection documents.